Cura Of Willmar
CURA OF WILLMAR in WILLMAR, MN — inspection on September 10, 2025.
Found 1 citation. Severity: Standard violations.
Health inspections identify deficiencies that facilities must correct within required timeframes. Violations range from minor documentation issues to serious safety concerns and are subject to follow-up verification.
Inspection Findings
had tested the doors at the facility on 8/26/25, but had not been out since. He said at that time the doors were functioning properly.During interview on 9/10/25, at 8:16 a.m., the former maintenance director said he did not think the doors would unlock if a wander alert device was near and said he never tested for that.
The former maintenance director said the used a bracelet (transmitter) and checked the doors on Mondays to make sure they locked. He said the device checker never worked on the doors.
The former maintenance director said he did not know who would be called if there were any technical issues with the wander alert system.During interview on 9/10/25 at 10:34 a.m., the RDO stated as far as he knew, the doors should not be able to unlock when pushed and held if the person was wearing a wander alert bracelet.
The RDO said he had reached out to a third party who was going to send a technician to look at the system.DoorGUARDIAN Installation Manual dated 12/6/2023, indicated the following recommended weekly testing: Patient Escort Feature Test- Enter the monitoring zone with a transmitter on your ankle.
The red light will turn on and the door will quietly lock.
Enter the primary reset code and the light will turn green, and the door will unlock.Anti-tailgate Feature Test- With the door locked, apply pressure on the opening hardware of the door.
The exit panel will begin to alarm, and the red light will remain on.
The light will remain red and the audible alarm will sound.
After 15 seconds the audible alarm will become a continuous tone and the door will release.
Open the door and the audible alarm will change to a seagull sound.
Close the door and enter the resent code.
The panel will stop alarming, and the door will re-lock.Remote Keypad test- repeat the steps above.Push Button Test- Pass through the door from the exit panel side using the reset code.
Close the door.
Depress the push button. No alarm condition will be activated.Advanced Security Mode Test- Bring a transmitter into the monitoring zone.
The green light will turn red; the yellow light will blink.
Now enter the reset code.
The red light will flash green momentarily indicating a valid code was entered while a monitored resident was nearby.
Next, try to gain access via the indoor/outdoor push button if one is installed.
With a transmitter in range, the door will remain locked, and an audible alarm will sound.
Only by entering the secondary reset code will access be granted in this situation.
Facility ID: